The feature of a electric slide rim saw and How to use it.
It is very convenient when the hive is made or there is a electric slide rim saw (electric slide round saw) to do Sunday carpentry with DIY. A good cutting of accuracy can be done more than a usual rim saw and a desk-top round saw.
The nest box for the bee is made with a electric slide rim saw.
The nest box for a Japanese bee can be made from the combination of the same parts. It is possible to do accurately and easily by use a rim saw usual to make a lot of same parts using a electric slide rim saw well.
What is a electric slide rim saw?
It is the one that this photograph installed Φ210mm electric slide rim saw Rage3S-300 of Evolution in a special installation stand. The cut material (wood) is fixed, and the rim saw is done in the slide.
Because the slide mechanism is steady, wood can be cut beautifully and early. If the same size is processed, it is possible to make it easily many.
The material is also easily good it is not only right-angled but also to cut the angle horizontally putting it. Of course, it can be easily done to be vertical and to put the angle.
If the usage of a electric slide rim saw is devised, the ditch can be carved for the material.
The main specification of Φ210mm electric slide rim saw Rage3S-300 of Evolution
Motor: 1,500W RPM : 3,000
The maximum incision depth (head 90 degrees): 60mm
The maximum incision depth (head 45 degrees): 35mm
Width of the maximum incision (turntable 90 degrees): 305mm
Width of the maximum incision (turntable 45 degrees): 210mm
Iron, aluminum, wood, and plastic can be cut with all one in special chip saw. (It is possible to cut it even by wood that the nail enters.)
The feature of a electric slide rim saw and How to use.
The merit of a electric slide rim saw is goodness of the cutting accuracy. Beauty and the straight line can be cut because there is no "Blurring" like a circular saw on hand. Cutting that applies the angle in the horizontal or vertical direction can be done accurately, too. In the one that the treatment device need not be used, it is possible to work early compared with a usual rim saw.
However, there is a weak point also in a electric slide rim saw. First of all, the price is high. And, because the main body grows as well as a desk-top round saw, some installation space is necessary. Moreover, a long and slender thing cannot be cut in length.
Usually setting up in a special worktable and using it are convenient though without fail it is likely to be able to carry just like a desk-top round saw.
Because it is possible to incline, not only a vertical cutting but also the inclination cutting is possible. the head (blade) Moreover, an accurate angle can be cut by rotating the turntable. Moreover, cutting that puts the inclination and the angle at the same time is also possible.
As for the model to which the laser light beam adheres, the laser beam is irradiated to the cut line. The width of the laser light beam should correct the position of the laser light beam in consideration of the width of cutting because it is narrow.
The ditch engraving
When the usage of a electric slide rim saw is devised, it is also possible to make the ditch in the material. The depth of the ditch can be decided by adjusting the screw that restricts the position in which saw falls. The length of the ditch can be easily processed in case of about 30cm. A electric slide rim saw is made to go back and forth and the width of the ditch is widened little by little.
How to choose electric slide rim saw
First of all, the cutting ability is the most important. If possible, You will buy the one with large ability.
Whether it is addition next laser that becomes standard at cutting position or not? The cutting position is not understood if there is no laser beam.
It is very convenient when there is a special installation stand with a slide round saw. The lengthy cargoes can cut, and are not more tired with stability than it puts directly on the floor and it uses it either.